The Clear Config Indication message is sent by an AC to request that a WTP reset its configuration to the manufacturing default configuration. The Clear Config Indication message is sent while in the Run CAPWAP state. The Clear Config Indication message carries no message elements. When a WTP receives a Clear Config Indication message it resets. APc1ae.f98c.e7c8#clear capwap private-config After that I reloaded the AP and he managed to register with the controller:.Jan 12 17:10:24.000:%CAPWAP-5-DTLSREQSEND: DTLS connection request sent peerip: 172.20.23.15 peerport: 5246. AP1240#clear lwapp private-config AP1240#lwapp ap hostname AP1240 AP1240#lwapp ap ip address 10.77.244.199 255.255.255.224. AP#clear capwap ap? All-config clear static configuration for WLC IP address (this command may cause termination session to WLC and new DTLS handshake) dot1x. UPDATE: So, I got the AP to CAPWAP, however, after a reboot of the AP I'm now seeing this:. 22: ipv6 gw config loop in discovery timer expiry. 22: ipv6 gw config loop in discovery timer expiry.
Clear Capwap Private-config
To remove factory default ap tag 945 from APHow to restore the factory settings on a Cisco Access Point
1. Through the CLI via console or SSH:
- login to the AP using Cisco/Cisco
2. Through the MODE button:
- Power off the AP
- While keeping the MODE button pressed, power on the AP.
- Still keep the MODE button pressed until the Status LED turns to red and then release it.
3. Installing via recovery image:
- Download the recovery image for 3500 from Cisco site.
- on AP Console write the command “Debug capwap console cli”
- Then write the commadn “Archive download-sw /overwrite /reload tftp:///”
Clearing the Controller Configuration on a Cisco Wireless LAN Controller
1. Through the CLI via console or SSH:
- login to the WLC
2 4 | clear config reload |
Enter clear config and enter y at the confirmation prompt to confirm the action.
Enter reset system. At the confirmation prompt, enter n to reboot without saving configuration changes. When the controller reboots, the configuration wizard starts automatically.
Follow the instructions in the “Using the Configuration Wizard” section on page 4-2 to complete the initial configuration.
Erasing the Controller Configuration on a Cisco Wireless LAN Controller
1. Through the CLI via console or SSH:
- login to the WLC
2 4 | reset system ! |
Clear Capwap Private-config
Enter reset system. At the confirmation prompt, enter y to save configuration changes to NVRAM. The controller reboots.
When you are prompted for a username, enter recover-config to restore the factory default configuration. The controller reboots and the configuration wizard starts automatically.
Follow the instructions in the “Using the Configuration Wizard” section on page 4-2 to complete the initial configuration.